The basic content, the brush

Brush: also known as the brush, brush.

Purpose: sealing, dustproof, water retaining, polishing, etc

Second, the article industrial I class

Sealing strip brushes, strap brush, stainless steel belt brush, horse hair brush, stainless steel wire brush, corrugated nylon brush, brick machine brush, nylon brush, etc.

Article 3, industrial brush

The extension of a brush products, be about to brush the spiral coil on the processed steel shaft, the fixed on both ends of the welding, characterized by brush density is big, don't fall off. And they can be made of tubular spring according to the size of the brush to install and replace by the customer, the cost is lower. Brush shaft can adopt 45 # round steel, ordinary stainless steel and 304 # stainless steel, etc., according to different purposes, brush wire can use sisal hemp, wool, PP wire, steel wire, stainless steel wire, copper wire, copper wire, plating abrasive wire and other materials.

Article 4, industrial brush application

Mainly applicable to:

The brush is widely applied in all kinds of automatic doors, Windows and doors, revolving door, sliding door, the elevator on the seal, and to cut off dust, prevent dust from entering the internal, and large industrial mechanical cleaning, glass edge grinding machine to block water seal, wind turbines, agriculture harvester the internal storage cover seal and washing machine brush, etc.

Article 5, industrial brush to clean

Article industrial brush need to pay attention to the following four questions:

Don't against the article brush brush to clean.

Article 1. The brush after cleaning, gently press with finger with tissue or cotton pad, let water ejection, but remember not to lay the bristles, otherwise it will damage the brush bristles, also can make the structure of the brush is loose, and lead to hair removal.

Article 2. The brush after cleaning brush can be hang up, let the brush Mao Chao under dry.

3. To air dry, can not blow dry, more do not dry in the sun, or you may hurt the brush material.

Article 6, industrial brush parameter information

Base material: stainless steel, electrolytic plate, galvanized sheet, low carbon steel

Brush length: 20 mm (minimum), 1000 mm and 1200 mm, 1500 mm and 2000 mm, 5000 mm and 10000 mm (longest), etc

The bottom of the steel strip thickness: minimum 2.5 mm (the thinnest), 3 mm, 3.5 mm, 4 mm, 4.5 mm, 5 mm, 12 mm thick (most)

Steel belt high side: such as 3 * 3 (3 mm thick lateral * 3 mm high) can do 3 * 4 (3 mm thick lateral * 4 mm high), 5 * 5 (5 mm thick * 5 mm side

High) can do 5 * 5 (5 mm thick lateral * 7 mm high). Can be adjusted according to request.